It`s time for fusion!

Neptune systems just made a pretty major announcement on Facebook.

 

Took a few tries but I just got in. Too bad I'm stuck at work for another 50 minutes.

 

Ive been wanting to get my apex hooked up for notifications but no where near tech enough to set it up. Sounds like this is alot easier.

 

So far I gotta say Fusion is pretty sweet.

 

Couldnt get it. No open spots

 

They open them every hour. It took me a few tries over a 15-20 minute period before I got a spot.

 

They closed it for the day. Tried for. 2 hours

 

"The pool of available slots will be refilled hourly so you can keep checking all day, everyday to see if you can get one."

 

Great! I've been using it for quite awhile. I do like it better than the old. There are a couple things I think are missing but hopefully they will add it on. They suggest using G Chrome. Hope you get it soon guys!

 

Got my invite

 

Anyone else having luck getting a beta slot? I think I've tried over 50 times now since their announcement on Friday, 3/14/14. Have my firmware all updated and ready to go whenever I finally get a spot!

 

I did, but I am not impressed just yet. Unless I am missing something the only cool thing is I can let you log on and see my setup and programs. Even let you control it! /DesktopModules/ActiveForums/themes/_default/emoticons/smile.gif

 

I would agree with not being impressed yet. I got a slot today, and so far I haven't seen anything too groundbreaking. (I've had remote access to my apex via VPN for as long as I've had it, so I'm a little spoiled) It was very easy to set up, so I'm sure that will be very appealing to some.

 

If you're not impressed, you could always give your slot to me! I still haven't been able to get one even after checking several times each day.

 

I just got in! Give it a try! About 754 am worked for me. Yayy. Too bad bestbuy isnt open so i can get my ethernet cable.

 

Friends don't let friends buy Ethernet cables from best buy.

 

While it does have a ways to go I think it is great so far. One thing I just found out after watching brs video, is you can begin programming outlets by selecting type of control. Then after entering the relevant info and switching the outlet to advanced it keeps the program in the form we are used to. As most of us know most outlets get set to advanced programming anyway, but for someone just getting started this type of programming would be useful to help learn some of the more confusing statements.

 

I can't control my outlets any problems doing that yourself?

 

Go into network settings and enable fusion control.

 

On apex or in fusion?