Attn Apex Users - Firmware 4.04 just released

Hey Apex users, Neptune Systems just released firmware version 4.04 BC-10.  The final release just came out yesterday.  Here's the version history so you can see what the new features are.  There have been quite a few updates this year so if you haven't updated your firmware in a while, now's a great time to do so.

Click here to download
Now remember, after you apply the firmware to the base unit, make sure that you go through and update the firmware on your modules too.  Log into the web interface.  Select Configuration / Module Setup.  Look at the SW_Rev column on the Apex Module List table at the bottom of the page.  If any of the say anything but (OK) next to the version number, you need to update the firmware.  You do this by going to the Module Configuration section (on the same page).  Select the module that's out of date from the drop down list.  Click Update Firmware, click Submit Module Change button.  Do this for each module.  FYI - this will power cycle your Energy Bar modules.  If you're using metal halides, do this outside of your photo period if you're not sure that you have your hysteresis set up properly. 
Enjoy!
--AJ